Contest
Click here to see who won our December 2012 WOW InnovAID!
Enter now our ‘Wonderful Ongoing World of InnovAID!’ contest! Closing midnight June 30, 2012.
Click here to see who won our December 2012 WOW InnovAID!
Enter now our ‘Wonderful Ongoing World of InnovAID!’ contest! Closing midnight June 30, 2012.
Fibre Content and Care Product Care can be found at the end of each item’s individual page. The same information can be found here in this order:
Heatable Lap Pads, Neck Curves, and Snake
No Heat Lap Pads, Neck Curves and Snake
Play Cape
Pressure Vest
Weighted Blanket – Large
Weighted Blanket – Travel sized
Weighted Vest – Custom
Weighted Vest – Standard
Weights for Vest
Wheelchair Blanket
Cover
Material:
100% Polyester
To wash:
Remove weight. Match all hook and loop tape so hook side is covered. Machine wash on gentle cycle or hand wash using detergent.
To dry:
Lay flat to dry or tumble dry on low heat. To prevent wrinkling, remove from dryer when slightly damp.
Insert
Material:
Water-resistant 100% polyester exterior
Rice interior
To wash:
Wipe water-resistant insert with damp cloth.
To dry:
Wipe with dry cloth or air dry.
Heating and Cooling
To heat:
Remove insert from cover. (Do not leave cover on because it will be too difficult to test the temperature of the insert.) Place insert on a clean plate (insert cannot be washed so keep as clean as possible). Place in microwave oven. Heat for 2 to 3 minutes — stop the microwave once or twice during the heating process to shake the insert. At the end of the 2 to 3 minutes, check temperature and shake insert. If required, continue to heat for 1 to 2 minutes more, again checking temperature and shaking insert as required. Place insert back into cover.
Caution:
If overheated, hot spots can occur. Letting the insert overheat in the microwave or repeatedly heating the insert within a short time frame can cause damage to the product or to the person using the product.
To cool: Store in a freezer
Cover
Material:
100% Polyester
To wash:
Remove insert. Match all hook and loop tape so hook side is covered. Machine wash on gentle cycle or hand wash using detergent.
To dry:
Lay flat to dry or tumble dry on low heat. To prevent wrinkling, remove from dryer when slightly damp.
Insert
Material:
Water-resistant nylon covering. Steel shot filling.
To wash:
Wipe water-resistant insert with damp cloth.
To dry:
Wipe with dry cloth or air dry.
Cape
Material:
A polyester/cotton blend. Fibre content varies with colour chosen.
To wash:
Remove weights. Machine wash on gentle cycle or hand wash using detergent. Use warm or cold water to maintain colour brightness.
To dry:
Lay flat to dry or tumble dry on low heat. To prevent wrinkling, remove from dryer when slightly damp. If required, iron cape with cool iron.
Weights
Material: Vinyl-covered weights filled with steel shot. Check weights occasionally for wear.
To wash: Wipe clean with damp cloth. Do not immerse in water.
Material: Neoplush.
To wash: Hand wash in cold water using pre-dissolved detergent. Rinse well in cold water.
To dry: Lay flat to dry.
Handling:
The weighted blanket consists of an insert and a removable cover. When handling the weighted blanket, do not pull just the cover — pull the entire cover and insert. If only the cover is pulled, the ties attaching the cover to the insert may tear.
Cover
Material:
Denim – 100% Cotton.
Fleece – 100% Polyester.
To wash:
Untie interior ties and remove insert. Machine wash cover on gentle cycle or hand wash using detergent. Use warm or cold water to maintain colour brightness.
To dry:
Lay flat to dry or tumble dry on low heat. To prevent wrinkling, remove from dryer when slightly damp.
Insert
Material:
Water-resistant nylon covering. Wool blend interior.
To wash:
Untie interior ties and remove insert. Wipe water-resistant insert with damp cloth. Machine washing is not recommended.
To dry:
Wipe with dry cloth or air dry.
To attach cover to insert:
Turn cover inside out. Lay cover flat with tie side up. Place insert on cover and tie the insert ties to the matching cover ties, EXCEPT for the tie near the corner where the zipper is. Do not double knot. Only tighten the bow securely. If the ties are double knotted it will be difficult to undo.
Reaching through the open zipper, grab the farthest corner (if using one hand) or two corners (if using two hands), and pull right-side out. Grab both the insert and the cover or the ties may tear. Shake gently until cover is completely right-side out. If forced, the zipper may be damaged. Tie the remaining tie at the zipper corner. Close zipper. Work corners so the blanket lies flat.
Cover
Material:
Denim – 100% Cotton.
Fleece – 100% Polyester.
To wash:
Untie interior ties and remove insert. Machine wash cover on gentle cycle or hand wash using detergent. Use warm or cold water to maintain colour brightness.
To dry:
Lay flat to dry or tumble dry on low heat. To prevent wrinkling, remove from dryer when slightly damp.
Insert
Material:
Water-resistant nylon covering. Wool blend interior.
To wash:
Untie interior ties and remove insert. Wipe water-resistant insert with damp cloth. Machine washing is not recommended.
To dry:
Wipe with dry cloth or air dry.
To attach cover to insert:
Turn cover inside out. Lay cover flat with tie side up. Place insert on cover and tie the insert ties to the matching cover ties. Do not double knot. Only tighten the bow securely. If the ties are double knotted, it will be difficult to undo.
Reaching through the open zipper, grab the farthest corner and pull right-side out. Grab both the insert and the cover or the ties may tear. Shake gently until cover is completely right-side out. If forced, the zipper may be damaged. Close zipper. Work corners so the blanket lies flat.
Vest
Material:
100% cotton base. Fibre content varies if another fabric is chosen.
To wash:
Remove weights. Match all hook and loop tape so hook side is covered. Machine wash on gentle cycle or hand wash using detergent. Use warm or cold water to maintain colour brightness.
To dry:
Lay flat to dry or tumble dry on low heat. To prevent wrinkling, remove from dryer when slightly damp.
Vest
Material:
100% cotton
To wash:
Remove weights. Match all hook and loop tape so hook side is covered. Machine wash on gentle cycle or hand wash using detergent. Use warm or cold water to maintain colour brightness.
To dry:
Lay flat to dry or tumble dry on low heat. To prevent wrinkling, remove from dryer when slightly damp.
Weights
Material:
Vinyl-covered weights filled with steel shot. Check weights occasionally for wear.
To wash:
Wipe clean with damp cloth. Do not immerse in water.
Material:
Vinyl exterior
Steel shot filling
To wash:
Wipe clean with damp cloth. Do not immerse in water.
Check weights occasionally for wear.
Handling:
The weighted blanket consists of an insert and a removable cover. When handling the weighted blanket, do not pull just the cover — pull the entire cover and insert. If only the cover is pulled, the ties attaching the cover to the insert may tear.
Material:
Fleece – 100% Polyester.
To wash:
Close all snaps. Machine wash on gentle cycle or hand wash using detergent. Use warm or cold water to maintain colour brightness.
Do not use bleach or excessively hot water.
To dry:
Lay flat to dry or tumble dry on low heat. To prevent wrinkling, remove from dryer when slightly damp.
Do not iron, press, or dry clean.
Comments are closed.
InnovAID Inc
92536 – 688 Wye Road
Sherwood Park, AB Canada
T8A 3X4
phone: 780-467-7627
fax: 780-416-2498
email: info@innovaid.ca